1986 911 Carrera

Stage 1- 207bhp-3.2litre flat 6, lowered ride height, 17” Cup 2 wheels.

Stage 2-400bhp/380tq-turbo conversion, bolt on stock internals, T4 turbo, RS America rear wing.

Stage 3- 681bhp/580tq-3.3litre pistons/cylinder kit, GT2 cams, HD valve springs with Ti retainers, 935 oil pump, ARP head studs and rod bolts, twin turbo conversion, T3/T4 hybrids, a few “tricks”, G50 transmission conversion with custom lightweight flywheel and puck clutch, Koni adjustable dampers, etc...

Stage 4- 300bhp/290tq-3.6 litre Varioram engine swap from 1996 C4s, twin turbo engine sold and replaced with almost stock 3.6-car is now for sale!  Lightweight flywheel, chip and custom dual exit exhaust. 

 

“Ronin”  2001 A4 Quattro S –line

Stage 1- 215bhp/245tq -1.8t  Revo software flash, turbo-back Nuespeed exhaust, UCC short shifter, Bilstein-H&R suspension combo, Nuespeed rear sway bar,  Reiger RS4 body kit.

Stage 2- 340bhp350tq-Gt28rs BT setup, custom software, Spec stage 3 clutch with Alu flywheel.

Stage3- 460bhp/500tq-2.7tt swap, RS4/K04 turbos, Revo stage 3 software flash, custom fueling kit, 034 Motorsports Bosch 044 drop in fuel pump, 3” custom stainless steel exhaust w/single 3” tip, Southbend stage 3 clutch setup, fully rebuilt 6 01E 6 speed transmission with 4:1 bias centre diff mod and JHM short shifter kit, Stoptech big brake kit, etc...
reef

“Reefgirl” 1990 Coupe Quattro

Stage 1- 227bhp/258tq-2.2 litre 20 valve turbo 5 cylinder AAN swap, custom front mount intercooler setup, H&R-Bilstein suspension combo, 17x8.5” Brock B1 wheels, S2 front bumper, Euro Coupe Quattro rear bumper, B4 hood conversion, with OEM RS2 headlight assemblies. 

Stage 2- 300bhp/350tq-addition of MTM stage II chip-set, 2.5” straight exhaust, 034 Motorsports High-Output Ignition coil kit.

Stage 3- ???400+???bhp/tq- yet to be determined...Fully rebuilt engine, over-bored, stroked, balanced and blueprinted block, with forged pistons, rods, ARP hardware through-out, Spec stage 3+ clutch with solid steel flywheel, fully prepared for upcoming gt30 OR gt35r custom turbo setup, with full 3” stainless steel exhaust.
reef

1993 90 Quattro

Stage 1- 172bhp/184tq-2.8 12 valve v6, stock, H&R=Bilstein suspension combo, 20mm rear sway bar, 17” RS4 replica wheels.

Stage 2- 210bhp/235tq-1.8t AEB swap, custom 2.5” turbo back
exhaust, Giac  software, Spec stage 3 clutch kit, short shifter kit.

Stage 3- 255bhp/280tq- K04 turbo, Giac k04 software.

reef

1996 A4 Quattro

Stage 1- 172bhp/184tq-2.8 12 valve v6, Reiger RS4 body kit, H&R coilover kit.

Stage 2- 200bhp/190tq-Stassis headers, full dual 2.5” exhaust with dual Remus mufflers, 19” RS4 wheels.

Stage 3- 210bhp/235tq-1.8t AEB swap, Unitronic software flash, Pearl white respray w/black roof and trunk.

 
reef

1990 Coupe Quattro

Stage 1- 330bhp/360tq-2.7tt swap, Revo software flash, 2.25” downpipes leading to stainless-steel 3” exhaust, custom front mount intercooler, S2 front bumper, B4 hood conversion with Euro headlights, H&R-Bilstein suspension combo, A8L front rotors with 993 callipers, 18” Porsche turbo twist wheels.

Stage 2- 485bhp/520tq-k04/k24 turbos, custom software and fuelling, Spec stage 3 clutch.

Stage 3- 640bhp/650tq-Single GT35r turbo, custom manifolds, stock internals, custom software and fuelling, 01E 5-speed transmission swap, custom A1 CV-tech axles, 18” BBS LM, Euro Coupe rear bumper, R32 front seats, etc...

Stage4- ????bhp/tq-swapping of connecting rods, 2.8 heads, etc... in preparation for turning up the boost and tuning on Brady’s dynapack, aiming for 10’s!